Mayday Ecu: Installation

HINT

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS )

1. INSTALL MOBILEPHONE BRACKET 
   1. Install the 2 mobilephone brackets with the 4 bolts
   Fig 1: Identifying Bolts And Mobilephone Brackets

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL MAYDAY ECU 
   1. Install the ECU with the nut.
   2. Connect the 4 connectors and 2 clamps
   Fig 2: Identifying Connectors And Clamps
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH  (See INSTALLATION )
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
5. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
6. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
7. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See INSTALLATION )
8. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
9. INSTALL ROPE HOOK  (See INSTALLATION )
10. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
11. INSTALL BATTERY SERVICE HOLE COVER  (See INSTALLATION )
12. INSTALL NO. 1 COOLER COVER  (See INSTALLATION )
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
14. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
16. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
17. PERFORM REGISTRATION 
    1. Perform registration (see REGISTRATION ).
       NOTE: When replacing the mayday battery or the mayday ECU (together with mayday battery), perform registration.