MULTI-DISPLAY (w/o Navigation System): Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS )

1. INSTALL NO. 2 RADIO BRACKET 
   1. Install the bracket with the 2 bolts.
      Fig 1: Locating Bolts And No. 2 Radio Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 RADIO BRACKET 
   1. Install the bracket with the 2 bolts.
3. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET 
   1. Connect the connectors.
      Fig 2: Locating Bolts And No. 1 Radio Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Insert the display and attach the 6 clips on its backside.

      HINT:

      Evenly push the right and left sides of the display into the instrument panel.

      Fig 3: Inserting Display

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the display with the 2 bolts.
4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET  (See INSTALLATION  )
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
6. INSTALL REAR UPPER CONSOLE PANEL  (See INSTALLATION )
7. INSTALL NO. 3 BOX PANEL  (See INSTALLATION )
   Fig 4: Locating Display With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
12. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
13. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )