Outer Rear View Mirror: Installation

HINT.

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY 
   1. Install the mirror with the 3 nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      Fig 1: Identifying Outer Rear View Mirror Assembly Nuts And Clamps

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Attach the 3 clamps
   3. Connect the connector.
2. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER  (See INSTALLATION )
3. INSTALL FRONT MULTIPLEX NETWORK DOOR ECU  (See INSTALLATION )
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See INSTALLATION )
5. INSTALL DOOR FRAME GARNISH  (See INSTALLATION )
6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See INSTALLATION )
7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See INSTALLATION )
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
   NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
9. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )