LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Brake System (Service Information)) >> Brake Pedal Support >> Removal

Brake Pedal Support: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/ close the doors while the battery is connected.
  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (see PRECAUTION ).
  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE BATTERY SERVICE HOLE COVER LH  (See REMOVAL )
  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE:
    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    • After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  5. REMOVE BATTERY SERVICE HOLE COVER  (See REMOVAL )
  6. REMOVE SERVICE PLUG GRIP  (See REMOVAL )
  7. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 
    1. Remove the instrument panel safety pad (see REMOVAL ).
  8. DISCONNECT CONNECTORS 
    1. Disconnect the brake pedal stroke sensor connector
      2. Fig 1: Locating Brake Pedal Stroke Sensor Connector And Stop Light Switch Connector
      G05781979Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the stop light switch connector, and then detach the wire harness clamp.
  9. REMOVE BRAKE PEDAL RETURN SPRING 
    1. Remove the spring.
      Fig 2: Locating Brake Pedal Return Spring
      G04949831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE PUSH ROD PIN 
    1. Remove the clip and push rod pin.
      Fig 3: Identifying Clip And Push Rod Pin
      G04949832Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY 
    1. Remove the 4 nuts.
      Fig 4: Locating Brake Pedal Support Assembly Nuts
      G04949833Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and brake pedal support.
      Fig 5: Locating Brake Pedal Support Bolts
      G04949834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals