Front Stabilizer Bar: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT CENTER FLOOR COVER (See REMOVAL )
REMOVE NO. 2 ENGINE UNDER COVER (See REMOVAL )
REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (See REMOVAL )
REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER (See REMOVAL )
REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR (See REMOVAL )
REMOVE FRONT STABILIZER LINK ASSEMBLY LH
1. Remove the 2 nuts and front stabilizer link.
  
  Fig 1: Locating Front Stabilizer Link Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.
REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Remove the RH side following the same procedures as the LH side.
REMOVE FRONT NO. 1 STABILIZER BRACKET LH
1. Remove the bolt and wire harness bracket.
  
  Fig 2: Locating No 2 Front Stabilizer Bracket With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
  
  Fig 3: Locating Front No. 1 Stabilizer Bracket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT NO. 1 STABILIZER BRACKET RH
1. Remove the bolt and disconnect the water with motor and bracket pump bracket.
  
  Fig 4: Identifying Water With Motor And Bracket Pump Bracket With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly
  
  Fig 5: Identifying Front No. 1 Stabilizer Bracket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT STABILIZER BAR
1. Remove the front stabilizer bar from the vehicle.
REMOVE FRONT NO. 1 STABILIZER BAR BUSH
1. Remove the 2 front No 1 stabilizer bar bushes from the front stabilizer bar.