Front Active Stabilizer Control Actuator: Inspection

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT STABILIZER LINK ASSEMBLY
1. Flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn Take the torque reading on the 5th turn.
  Standard turning torque:
  
  1.96 N.m (20 kgf.cm, 17.3 in. lbf.) or less
  
  If the value is not within the specified range, replace the front stabilizer link assembly
3. Check the dust boot for cracks or grease leakage
  
  Fig 1: Inspecting Front Stabilizer Link Ball Joint
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002