Front Passenger Airbag Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
1. Attach the 5 hooks (A).
2. Attach the 5 hooks (B) and install the front passenger airbag on the instrument panel.
  
  Fig 1: Locating Front Passenger Airbag Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 2 screws.
  
  Fig 2: Identifying Front Passenger Airbag Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the 2 connectors and install the instrument panel wire assembly to the front passenger airbag.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 3: Locating Front Passenger Airbag Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 HEATER TO REGISTER DUCT (See REASSEMBLY )
INSTALL DEFROSTER NOZZLE ASSEMBLY (See INSTALLATION )
INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT (See INSTALLATION )
INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT (See REASSEMBLY )
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).