LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Supplemental Restraint System) >> Driver Side Knee Airbag Assembly >> Installation

Driver Side Knee Airbag Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    Fig 1: Locating Driver Side Knee Airbag Bolts
    G05775078Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Connect the connector.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Install the driver side knee airbag with the 4 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 in.*lbf) 

    3. Attach the claw to install the lock lever.
    4. Install the control cable.
  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING  (See INSTALLATION )
  5. INSTALL INSTRUMENT SIDE PANEL LH  (See INSTALLATION )
  6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  8. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
  9. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
  10. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see INITIALIZATION  ).
scientia non olet · About LEMON Manuals