LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Removal

Center Airbag Sensor Assembly: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE BATTERY SERVICE HOLE COVER LH  (See REMOVAL )
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE:
    • After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE NO. 3 BOX PANEL  (See REMOVAL )
  8. REMOVE REAR UPPER CONSOLE PANEL  (See REMOVAL )
  9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE LOWER CONSOLE COVER  (See REMOVAL )
  12. REMOVE CONSOLE BOX ASSEMBLY  (See REMOVAL )
  13. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    1. Disconnect the holder (with connectors).
    2. Remove the 3 bolts and airbag sensor.
      Fig 1: Locating Center Airbag Sensor Assembly Bolts
      G04951314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals