Differential Oil: Replacement
WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
- DRAIN DIFFERENTIAL OIL
- Stop the vehicle on a level place.
- for Front Differential:
- Using a 10 mm hexagon wrench, remove the filler plug and gasket.
- Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
- Using a 10 mm hexagon wrench, install a new gasket and the drain plug
Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
- for Rear Differential.
- Using a 10 mm hexagon wrench, remove the filler plug and gasket.
- Using a 10 mm hexagon wrench, remove the dram plug and gasket, and drain the oil.
- Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
Torque: 49 N*m (500 kgf*cm, 37 ft.*lbf)
- ADD DIFFERENTIAL OIL
- for Front Differential:
- Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the differential filler plug holeNOTE:
- Too much or too little oil will lead to differential problems.
- After changing the oil, drive the vehicle and then check the oil level again.
Oil type:
Toyota Genuine Differential Gear Oil LT 75W-85 GL-5 or equivalent.
Capacity:
0.7 to 0.8 liters (0.74 to 0.84 US qts., 0.62 to 0.70 lmp. qts.)
- Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
- Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the differential filler plug hole
- for Rear Differential.
- Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the differential filler plug hole.NOTE:
- Too much or too little oil will lead to differential problems.
- After changing the oil, drive the vehicle and then check the oil level again.
Oil type:
Toyota Genuine Differential Gear Oil LX 75W-85 GL-5 or equivalent
Capacity:
1.3 to 1.4 liters (1.38 to 1.47 US qts., 1.15 to 1.23 lmp. qts.)
- Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
- Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the differential filler plug hole.
- for Front Differential: