Front Wiper Rubber: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for both the RH and LH side
The procedures listed below are for the LH side

INSTALL WIPER RUBBER LH
1. Install the 2 backing plates to the rubber
  NOTE: Make sure the backing plates are facing the proper direction.
  
  Fig 1: Installing Backing Plates To Rubber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.
  HINT:
  
  Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.
  
  Fig 2: Installing Wiper Rubber To Claw Of Wiper Blade
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Attach the head part (large side) of the wiper rubber to the rear end side claw of the wiper blade
HINT.

Push the wiper blade into the grooves of the wiper rubber to attach if completely.
INSTALL FRONT WIPER BLADE LH
1. Install the wiper blade as shown in the illustration.
Fig 3: Installing Wiper Blade
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002