LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emission Control) >> Fuel Tank Pressure Sensor >> Removal

Fuel Tank Pressure Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL TANK ASSEMBLY 
    1. Remove the fuel tank from the vehicle (see REMOVAL ).
  2. REMOVE NO. 3 FUEL TANK PROTECTOR 
    1. Release the lock and then turn the protector and remove it.
      2. Fig 1: Removing No. 3 Fuel Tank Protector
      G05773172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FUEL TANK PRESSURE SENSOR 
    1. Disconnect the pressure sensor connector
    2. Remove the tube joint clip and pressure sensor.
      NOTE:
      • Before removing the tube joint clip, check for foreign matter around the tube joint clip. Clean if necessary.
      • Keep the O-ring free of foreign matter, as it becomes contaminated easily.
      • Do not use any tools in this procedure.
      • Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.
        Fig 2: Removing Tube Joint Clip And Pressure Sensor
        G05303392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FUEL TANK BREATHER TUBE GASKET 
    1. Remove the 4 screws, fuel tank protector plate, fuel tank EVAP tube support plate and gasket
      Fig 3: Locating Fuel Tank Breather Tube Gasket Screws
      G05303393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals