Inspection Procedure
- RAD VALUE USING TECHSTREAM (CLEARANCE LIGHT)
- Using the Techstream, read the Data List.
Body No. 5
BODY NO. 5 DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note Clearance Light Tr Clearance light illumination condition display/OK - Overheat - Overload OK: Normal
Overheat: ECU overheats
Overload: ECU overload- OK:
Normal condition listed above is displayed.
NG: Go to step 2
OK: REPLACE MULTIPLEX NETWORK FRONT LIGHT ECU
- Using the Techstream, read the Data List.
- CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK FRONT LIGHT ECU - HEADLIGHT)
- Disconnect the B14 ECU connector.
- Disconnect the B2 and B12 light connectors.
- Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LH
RESISTANCE SPECIFIED CONDITIONSTester Connection Condition Specified Condition B14-23 (CRAL) - Body ground Always 10 kΩ or higher for RH
RESISTANCE SPECIFIED CONDITIONSTester Connection Condition Specified Condition B14-15 (CRAR) - Body ground Always 10 kΩ or higher Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
- CHECK CLEARANCE LIGHT BULB (OPERATION)
- Temporarily replace the clearance light bulb with a new or normally functioning one (see DISASSEMBLY ).
- Check for DTC (see DTC CHECK/CLEAR
).
OK:
DTC B2482 output does not occur.
NG: Go to step 4
OK: END (REPLACE CLEARANCE LIGHT BULB) (See DISASSEMBLY )
- CHECK HEADLIGHT ASSEMBLY (OPERATION)
- Temporarily replace the headlight with a new or normally functioning one (see REMOVAL ).
- Check for DTC (see DTC CHECK/CLEAR
).
OK:
DTC B2482 output does not occur.
NG: REPLACE MULTIPLEX NETWORK FRONT LIGHT ECU
OK: END (REPLACE HEADLIGHT ASSEMBLY) (See REMOVAL )