Rear Lower Arm: Inspection

INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.
  Standard turning torque:
  
  5.0 N*m (51 kgf*cm, 44 in.*lbf) or less
  
  Fig 1: Inspecting Rear No. 1 Suspension Arm Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002