LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 460 AWD >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering >> Dc/Dc Converter >> Removal

Dc/Dc Converter: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disconnect the negative (-) battery cable from the battery terminal.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
      NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE BATTERY 
    1. Disconnect the positive (+) battery cable from the battery terminal.
    2. Remove the 2 nuts and battery clamp.
    3. Remove the battery insulator.
    4. Remove the battery.
  4. REMOVE BATTERY TRAY 
    1. Remove the 3 bolts and battery tray.
  5. REMOVE DC-DC CONVERTER 
    1. Release the locks of the 2 converter assembly connectors A and B, and disconnect the connectors.
      Fig 1: Releasing Locks Of Converter Assembly Connectors A And B
      G04944399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and converter.
      Fig 2: Locating Converter Assembly Bolts
      G04944400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals