LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> LS 460 AWD >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Purge Valve >> Installation

Purge Valve: Installation

  1. INSTALL PURGE VSV 
    1. Install the purge VSV with the bolt.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    2. Connect the 2 purge line hoses to the purge VSV.
    3. Connect the purge VSV connector.
      4. Fig 1: Locating Purge VSV Connector And Purge Line Hoses
      G04943730Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT ENGINE WIRE  (See INSTALLATION )
  3. INSTALL AIR CLEANER CAP LH 
    1. Install the air cleaner cap LH.
  4. INSTALL AIR CLEANER CAP RH 
    1. Install the air cleaner cap RH.
  5. INSTALL INTAKE AIR CONNECTOR PIPE  (See INSTALLATION )
  6. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  7. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  9. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  10. INSTALL AIR CLEANER INLET COVER  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  12. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
scientia non olet · About LEMON Manuals