How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the sliding roof system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK LIN COMMUNICATION SYSTEM* 
   1. The sliding roof system uses the LIN communication system to communicate. Check that the LIN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      LIN communication system is normal	A
      LIN communication system is malfunctioning	B

      B:  Go to LIN COMMUNICATION SYSTEM

      A: Go to Next Step 

4. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Using the Techstream, check if the CAN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B:  Go to CAN COMMUNICATION SYSTEM

      A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Data List/Active Test (see DATA LIST/ACTIVE TEST  )
   2. Terminals of ECU (see TERMINALS OF ECU  )
   3. Operation Check (see OPERATION CHECK  )
7. ADJUST, REPAIR OR REPLACE 
8. INITIALIZATION 
   1. Initialization (see INITIALIZATION  )
9. CONFIRMATION TEST 

   NEXT: END