DTC B2602: Key Unlock Warning Switch Circuit Malfunction; DTC B2606: Key Code Confirm Signal Malfunction: Procedure

HINT: 

The power tilt and power telescopic steering column system uses the multiplex communication system, so check its diagnostic system before proceeding to troubleshooting.

1. Check if DTC B2621 is output.

   Result

   Result	Proceed to
   No output	A
   B2621 is output	B

   HINT: 

   • If DTC B2621 besides B2602 and B2606 are output, perform troubleshooting for B2621 first.
   • DTC B2621 indicates a communication interruption for the power tilt and power telescopic steering column system.

B → See step   4 

A: Go to next step 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Check the communication state of the Techstream. Enter the following menus: Chassis / Tilt&Telescopic / Data List.
   TILT&TELESCOPIC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Key Code Confirm(MPX)	Communication state of key code confirmation signal/ ON or OFF	ON: Communication is normal OFF: Communication is interrupted	-
   IG Switch (MPX)	Communication state of engine switch/ ON or OFF	ON: Communication is normal OFF: Communication is interrupted	-

   OK

   "ON" is displayed.

NG → See step   5 

OK: Go to next step 

1. Clear the DTC. Refer to DTC CHECK / CLEAR .
2. Check for DTCs. Refer to DTC CHECK / CLEAR .

   OK

   DTC B2602 and/or B2606 is not output.

NG → See step   6 

OK → END