DTC C1516: Torque Sensor Zero Point Adjustment Incomplete; DTC C1526: Rotation Angle Sensor Initialization Incomplete: Procedure

NEXT: Go to next step 

1. Initialize the rotation angle sensor and calibrate the torque sensor zero point. Refer to CALIBRATION .

NEXT: Go to next step 

1. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times*1.	A
   DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 1 or 2 times*2.	B
   Normal system code is output.	C

   HINT: 

   • *1: The power steering ECU assembly must be replaced if DTCs are still output even after initialize the rotation angle sensor and calibrate the torque sensor zero point.
   • *2: Perform the rotation angle sensor initialization and torque sensor zero point calibration again if DTCs are still output even after the initialization and calibration is performed 1 or 2 times.

C → END 

B → See step   9 

A: Go to next step 

1. Replace the power steering ECU assembly. Refer to REMOVAL .

NEXT: Go to next step 

NEXT: Go to next step 

1. Initialize the rotation angle sensor value and calibrate the torque sensor zero point. Refer to CALIBRATION .

NEXT: Go to next step 

1. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times*1.	A
   DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 2 times*2.	B
   Normal system code is output.	C

   HINT: 

   • *1: The power steering gear assembly must be replaced if DTCs are still output even after initialize the rotation angle sensor and calibrate the torque sensor zero point.
   • *2: Perform the rotation angle sensor initialization and torque sensor zero point calibration again if DTCs are still output even after the initialization and calibration is performed 2 times.
   NOTE:

   If replacing the power steering gear assembly, clear the rotation angle sensor calibration value, initialize the rotation angle sensor value, and calibrate the torque sensor zero point. Refer to CALIBRATION .

C → END 

B → See step   9 

A → See step   8