Voice is not Recognized: Procedure

1. Enter the "Menu" screen by pressing the "MENU" switch.
   Fig 1: Diagnostic Tool Display - SET UP

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Select "Set up".
3. Check that "Voice Recognition Guidance" is not OFF.
   Fig 2: Checking Voice Recognition Guidance Is Not OFF

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   Voice Recognition Guidance is not OFF.

NG → TURN VOICE RECOGNITION GUIDANCE "ON" 

OK: Go to next step 

1. Check that the map disc is not deformed or cracked.
   Fig 3: Ensure Map Disc Is Not Cracked Or Deformed

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   No deformations or cracks on the map disc.

NG → REPLACE MAP DISC 

OK: Go to next step 

1. Check for dirt on the map disc surface.
   Fig 4: Cleaning Disc

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   No dirt is on the map disc surface.

   NOTE:

   Do not use a conventional record cleaner or antistatic preservative.

   HINT: 

   If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

NG → CLEAN MAP DISC 

OK: Go to next step 

1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode. Refer to OPERATION CHECK .
   Fig 5: Diagnostic Tool Display - Microphone & Voice Recognition Check

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
3. Push the recording switch and perform voice recording.

   HINT: 

   Voice can be recorded up to 5 seconds.

4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

   OK

   All check results are normal.

NG → See step   5 

OK → See step   6 

1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode. Refer to OPERATION CHECK .
   Fig 6: Diagnostic Tool Display - Microphone & Voice Recognition Check Mode

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
3. Push the recording switch and perform voice recording.

   HINT: 

   Voice can be recorded up to 5 seconds.

4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

   OK

   All check results are normal.

NG → See step   7 

OK → END