4WD Control Ecu: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL 4WD CONTROL ECU
1. Connect the connector and clamp to the 4WD control ECU.
  
  Fig 1: Connecting Connector & Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 4WD control ECU with the bolt and nut.
  
  Fig 2: Installing 4WD Control ECU With Bolt & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Bolt
  
  Torque: 14 N*m ( 137 kgf*cm, 10 ft.*lbf)
  
  Nut
  
  Torque: 6.0 N*m ( 61 kgf*cm, 54 in.*lbf)
3. Connect the junction connector with the 2 clips.
  
  Fig 3: Connecting Junction Connector With 2 Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 16
INSTALL SIDE INSTRUMENT PANEL RH . Refer to INSTALLATION - Step 17
INSTALL FRONT DOOR OPENING TRIM COVER RH . Refer to INSTALLATION - Step 18
INSTALL FRONT DOOR SCUFF PLATE RH (w/o Illumination)
HINT:

Use the same procedures for the RH side and the LH side. Refer to INSTALLATION - Step 28 .
INSTALL FRONT DOOR SCUFF PLATE RH (w/ Illumination)
HINT:

Use the same procedures for the RH side and the LH side. Refer to INSTALLATION - Step 29 .