Pattern Select Switch Circuit: Procedure

1. Disconnect the connector of the pattern select switch.
   Fig 1: Checking Harness And Connector Between Pattern Select Switch & Body Ground

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Specified Condition
   4 - Body ground	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.
   Fig 2: Identifying E4 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard resistance

   Switch Condition	Tester Connection	Specified Condition
   Pattern select switch continuously pressed (2nd STRT)	3 - 4	Below 1 Ω
   Pattern select switch released (2nd STRT)	↑	10 kΩ or higher

NG → REPLACE PATTERN SELECT SWITCH ASSEMBLY 

OK: Go to next step 

1. Connect the connector of the pattern select switch.
   Fig 3: Checking Harness And Connector Between Pattern Select Switch & ECM

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Switch Condition	Tester Connection	Specified Condition
   Pattern select switch continuously pressed (2nd STRT)	E8-27 (SNWI) - Body ground	Below 1 Ω
   Pattern select switch released (2nd STRT)	↑	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE