LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> GS 450h >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control (SFI) System (Diagnostic Codes (P0010-P0365)) >> SFI System >> DTC P0111: Intake Air Temperature Sensor Gradient Too High >> Typical Enabling Conditions

Typical Enabling Conditions

ALL:

Monitor runs whenever these DTCs are not present None
Battery voltage 10.5 V or more
AFTER ENGINE STOP:

Time after engine start 10 seconds or more
ECT sensor (P0115, P0117, P0118) OK
Accumulated MAF amount before engine stop 3140 g or more
Key-off duration 30 minutes
AFTER COLD ENGINE START:

Key-off duration 5 hours or more
Time after engine start 10 seconds or more
ECT sensor (P0115, P0117, P0118) OK
ECT 70°C (158°F) or more
Accumulated MAF amount 3140 g or more
One of the following conditions 1 or 2 is met: -
1. Duration while engine load is low 120 seconds or more
2. Duration while engine load is high 10 seconds or more