How To Proceed With Troubleshooting

HINT: 

• Use theses procedures to troubleshoot the rear view monitor system.
• *: Use Techstream.

1. VEHICLE BROUGHT WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. CHECK CAMERA LENS 
   1. Check that the camera lens is not dirty with mud, foreign matter, etc.

      NEXT: Go to next step 

4. BASIC INSPECTION 
   1. Turn the engine switch on(ACC).
   2. Check whether or not the display appears on the multi-display.
      Result
      
      

      Result	Proceed to
      Display appears	A
      Display does not appear	B

      B → Go to NAVIGATION SYSTEM 

      A: Go to next step 

5. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use Techstream to check if the CAN Communication System is functioning normally.
      Result
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

      B → Go to CAN COMMUNICATION SYSTEM 

      A: Go to next step 

6. PROBLEM SYMPTOMS TABLE 
   Result
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step 8 

   A: Go to next step 

7. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU . Refer to TERMINALS OF ECU .

      NEXT: Go to next step 

8. ADJUST, REPAIR OR REPLACE 

   NEXT → END