Vane Pump: Installation

INSTALL VANE PUMP ASSEMBLY
1. Install the power steering vane pump with the nut.
  Torque: 43 N*m (440 kgf*cm, 32 ft.*lbf)
2. Install the 2 bolts.
  Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)
3. Install the pressure feed tube and a new gasket to the pressure feed hose union bolt.
  HINT:
  
  Make sure the stopper of the pressure feed tube touches the power steering vane pump body as shown in the illustration, then torque the union bolt.
  
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
4. Connect the return hose with the clip.
5. Connect the 2 vacuum hoses with the 2 clips.
INSTALL FAN AND GENERATOR V BELT
1. Put a wrench on the drive belt tensioner set bolt.
2. Turn the drive belt tensioner set bolt counterclockwise and hold it.
  HINT:
  
  The drive belt tensioner set bolt has a left-hand thread. The drive belt tensioner set bolt loosens when it is turned clockwise.
  
  Fig 2: Turning Drive Belt Tensioner Set Bolt Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the fan and generator V belt.
4. Release the drive belt tensioner.
  HINT:
  
  The drive belt tensioner is an auto tensioner.
INSTALL AIR CLEANER ASSEMBLY
1. Install the air cleaner with the 3 bolts.
2. Install the clamp.
3. Connect the MAF meter connector.
INSTALL NO. 1 AIR CLEANER INLET
1. Install the air cleaner inlet with the bolt.
INSTALL ENGINE UNDER COVER REAR RH
1. Install the under cover with the 2 bolts.
INSTALL ENGINE UNDER COVER
1. Install the under cover with the 16 bolts.
BLEED AIR FROM POWER STEERING SYSTEM (See ON-VEHICLE INSPECTION )
INSPECT POWER STEERING FLUID LEAK