Headlight Assembly: Removal

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE RADIATOR GRILLE (See REMOVAL )
REMOVE FRONT FENDER LINER LH (See REMOVAL )
REMOVE FRONT FENDER LINER RH (See REMOVAL )
REMOVE FRONT BUMPER ENERGY ABSORBER
REMOVE FRONT BUMPER COVER (See REMOVAL )
REMOVE HEADLIGHT ASSEMBLY
1. Remove the 2 bolts, nut and clip.
2. Disconnect the connectors.
  
  Fig 1: Identifying Headlight Assembly Bolts And Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Pull out the unit in the direction indicated by the arrow in the illustration.