Fog Light Assembly: Adjustment

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST FOG LIGHT AIMING
1. Make sure that the tire inflation pressure is the specified value (120 kPa (1.2 kgf/cm² , 17 psi)).
2. Start the engine.
3. Insert the screwdriver tip into the hole in the front bumper and rotate the aiming screw while observing through the front bumper (vertical adjustment).
  
  Fig 1: Inserting Screwdriver Tip Into Hole In Front Bumper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Rotating the screwdriver clockwise aims the fog light axis downward, and rotating counterclockwise aims it upward.