LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> SC 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Starting) >> Starter >> Installation

Section 21 (Starting): Starter: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the wire clamp to the wire protector with the bolt.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    2. Connect the starter cable with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the starter connector.
      Fig 1: Locating Wire Clamp To Wire Protector With Bolt
      G05289463Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the starter with the 2 bolts.

      Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf) 

  2. INSTALL WATER BY-PASS PIPE SUB-ASSEMBLY (See  INSTALLATION  ) 
  3. INSTALL REAR WATER BY-PASS JOINT (See  INSTALLATION  ) 
  4. INSTALL INTAKE MANIFOLD SUB-ASSEMBLY 
    1. Install the intake manifold (see INSTALLATION ).
      Fig 2: Locating Starter With Bolt
      G05289464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals