Inspection Procedure

1. Check the DATA LIST for proper functioning of the steering pad switch.

   Steering pad switch modulator: 

   DATA LIST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   AV MODE SW	Audio mode switch / ON or OFF	ON: Audio mode switch is pushed OFF: Audio mode switch is not pushed	-
   AV VOL UP SW	Audio volume UP switch / ON or OFF	ON: Audio volume UP switch is pushed OFF: Audio volume UP switch is not pushed	-
   AV VOL DOWN SW	Audio volume DOWN switch / ON or OFF	ON: Audio volume DOWN switch is pushed OFF: Audio volume DOWN switch is not pushed	-
   AV SEL UP SW	Audio selector UP switch / ON or OFF	ON: Audio selector UP switch is pushed OFF: Audio selector UP switch is not pushed	-
   AV SEL DOWN SW	Audio selector DOWN switch / ON or OFF	ON: Audio selector DOWN switch is pushed OFF: Audio selector DOWN switch is not pushed	-
   AV VOL SET SW	Audio volume set switch / ON or OFF	ON: Audio volume set switch is pushed OFF: Audio volume set switch is not pushed	-
   VOICE HOOK SW*	Speech recognition hook switch / ON or OFF	ON: Speech recognition hook switch is pushed OFF: Speech recognition hook switch is not pushed	-
   HINT: *: w/ Navigation System

   OK: 

   ON appears on the screen when each steering pad switch is pushed. 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

NG: Go to next step 

1. Replace steering pad switch.
2. Check if the vehicle is equipped with a navigation system.

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   w/ Navigation system	A
   w/o Navigation system	B

B: END 

A: Go to next step 

1. The following procedure must be completed within 30 seconds:
   1. Turn the ignition switch to ACC.
   2. Press the "Mode" button for at least 10 seconds.
   3. Within 5 seconds, press channel up twice and channel down twice.

NEXT: END