Inspection Procedure

1. Check the Data List to ensure proper function of the front passenger door lock switch.

   BODY (Body ECU): 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Door Lock SW-LOCK	Door lock switch signal /ON or OFF	ON: Door lock switch is pushed to LOCK position OFF: Door lock switch is not pushed to LOCK position	-
   Door Lock SW-UNLOCK	Door unlock switch signal /ON or OFF	ON: Door lock switch is pushed to UNLOCK position OFF: Door lock switch is not pushed to UNLOCK position	-

   OK: The display is as specified in the normal condition. 

NG: Go to step 2 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

1. Remove the door control switch assembly.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   2 - 3	Lock	Below 1 Ω
   2 - 3 1 - 2	OFF (Free)	10 kΩ or higher
   1 - 2	Unlock	Below 1 Ω

Fig 1: Inspecting Door Control Switch Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE DOOR CONTROL SWITCH ASSEMBLY 

OK: Go to next step 

1. Disconnect the door control switch assembly connector.
2. Disconnect the instrument panel J/B connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   D12-3 - 1J-3	Always	Below 1 Ω
   D12-1 - 1J-4	Always	Below 1 Ω
   D12-2 - Body ground	Always	Below 1 Ω

Fig 2: Checking Wire Harness (Door Control Switch Assembly - Instrument Panel J/B)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE