Rear Circuit Breaker Sensor: Installation

1. INSTALL REAR CIRCUIT BREAKER SENSOR 
   1. Install the rear circuit breaker sensor (RH).
      1. Install the circuit breaker sensor (RH) with the 2 bolts.

         Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

         Fig 1: Locating Rear Circuit Breaker Sensor And Bolts

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Connect the connector to the rear circuit breaker sensor (RH).
      Fig 2: Locating Rear Circuit Breaker Sensor RH Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the rear circuit breaker sensor (LH).
      1. Install the rear circuit breaker sensor (LH) with the 2 bolts.

         Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

         Fig 3: Locating Rear Circuit Breaker Sensor And Bolts

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Connect the connector to the rear circuit breaker sensor (LH).
      Fig 4: Locating Rear Circuit Breaker Sensor LH Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL DECK SIDE TRIM BOX RH 
3. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
4. INSTALL DECK BOARD SUB-ASSEMBLY NO. 2  (See INSTALLATION )
5. INSTALL DECK BOARD SUB-ASSEMBLY NO. 3  (See INSTALLATION )
6. INSTALL DECK FLOOR BOX FRONT  (See INSTALLATION )
7. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
8. INSTALL DECK FLOOR BOX REAR  (See INSTALLATION )
9. INSTALL DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
11. PERFORM INITIALIZATION 

Some systems need initialization when disconnecting the cable from the negative battery terminal. (See INITIALIZATION )