DTC Check / Clear

DTC CHECK/CLEAR
HINT:
- Check and clear the DTC for the brake control system, the axle system is controlled by the brake control system (skid control ECU) and hybrid control system (HV control ECU).
- If a DTC other than DTC C1348 is output when performing DTC check, refer to DTC chart of the Brake Control System (See DIAGNOSTIC TROUBLE CODE CHART ).
1. Check the DTCs.
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to the ON position.
  3. Check the DTCs by following the prompts on the tester screen.
    HINT:
    
    Refer to the Techstream operator's manual for further details.
2. Code is explained in the DTC chart (See DATA LIST / ACTIVE TEST ).
3. Clear the DTCs.
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to the ON position.
  3. Clear the DTCs by following the prompts on the tester screen.
    HINT:
    
    Refer to the Techstream operator's manualfor further details.
END OF DTC CHECK/CLEAR
1. Turn the ignition switch to the ON position.
2. Check that "CHECK AWD SYSTEM" is not displayed on the multi-information display.