Inspection Procedure

CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO DLC3 (TS))

Turn the ignition switch off.
Disconnect the skid control ECU connector.

Measure the resistance according to the value (s) in the table below.

Resistance

RESISTANCE SPECIFICATION CHART

Tester Connection	Specified Condition
S39-32 (TS) - D1-12 (TS)	Below 1 Ω

Fig 1: Identifying Skid Control ECU Connector And DLC3 Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: Go to Next Step

CHECK HARNESS AND CONNECTOR (DLC3 (CG) TO BODY GROUND)

Measure the resistance according to the value (s) in the table below.

Resistance

RESISTANCE SPECIFICATION CHART

Tester Connection	Specified Condition
D1-4 (CG) - Body ground	Below 1 Ω

Fig 2: Identifying CG Terminal Of DLC3

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: Go to Next Step

CHECK HARNESS AND CONNECTOR (DLC3 (TS) TO BODY GROUND)

Measure the resistance according to the value (s) in the table below.

Resistance

RESISTANCE SPECIFICATION CHART

Tester Connection	Specified Condition
D1-12 (TS) - Body ground	10 kΩ or higher

HINT:

If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).

Fig 3: Identifying TS Terminal Of DLC3

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: REPLACE SKID CONTROL ECU