Data List / Active Test

HINT:

Using the Data List displayed on Techstream, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the Data List as the first step in troubleshooting is one way to shorten the labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the tester on.
4. Select the following menu items: Body Electrical / Immobilizer / Data List.
5. Read the Data List according to the display on the tester.

   Immobilizer: 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Key SW	Unlock warning switch signal / ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder	-
   IG SW	Ignition switch signal / ON or OFF	ON: Ignition switch on OFF: Ignition switch off	-
   Immobilizer	Immobilizer system status / SET or UNSET	UNSET: Ignition switch on SET: Without key	-
   Response	Transponder chip data / NG or OK	NG: Data error OK: Data OK	-
   Frame Error	Transponder chip data / NG or OK	NG: Data error OK: Data OK	-
   Different Serial Number	Transponder chip data / NG or OK	NG: Data error OK: Data OK	-
   Different Encrypt Code	Transponder chip data / NG or OK	NG: Data error OK: Data OK	-
   Abnormal Status	Transponder chip data / NG or OK	NG: Data error OK: Data OK	-
   Bcc Malfunction	Transponder chip data / NG or OK	NG: Incorrect data being sent. OK: Correct data being sent.	-
   Sub Key	Sub key code signal / NOMATH or MATCH	NOMATCH: Non matching sub key code is sent. MATCH: Sub key code is sent.	-
   Master Key	Master key code signal / NOMATH or MATCH	NOMATCH: Non matching master key code is sent. MATCH: Master key code is sent.	-
   Transponder S-Code	Number of registered sub key / min. 0, max. 15	Number of registered sub key.	-
   Transponder M-Code	Number of registered master key /min. 0, max. 15	Number of registered master key.	-
   Reg Code Space Full	Memory space for key codes registration / NOT FUL or FULL	NOT FUL: More key code registration possible. FULL: No more key code registration possible.	-
   +B	Power source / BRAKE or NORMAL	BRAKE: Power source open. NORMAL: Power source normal.	-
   Antenna Coil Status	Antenna coil condition / NORMAL or FAIL	NORMAL: Antenna coil is normal. FAIL: Antenna coil is malfunctioning.	-

HINT:

Performing the Active Test using Techstream allows the relay, VSV, actuator, etc. to operate without removing any parts. Performing the Active Test as the first step of troubleshooting is one way to shorten labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the tester on.
4. Select the following menu items: Body Electrical / Immobilizer / Active Test..
5. Perform the Active Test according to the display on the tester.

   Immobilizer: 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Security Indicator	Turn security indicator	ON / OFF	-