Park / Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the 2 bolts.
3. Place a new lock plate and tighten the nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
4. Temporarily install the control shaft lever.
  
  Fig 1: Locating Lock Nut And Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the lever counterclockwise until it stops and then turn it clockwise 2 notches.
6. Remove the control shaft lever.
  
  Fig 2: Turning Lever Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the groove with the neutral basic line.
8. Hold the switch in position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 3: Aligning Groove With Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Using a screwdriver, bend the tabs of the lock plate.
  
  Fig 4: Bending Tabs Of Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever, washer and the nut.
  Torque: 13 N*m(130 kgf*cm, 9 ft.*lbf)
  
  Fig 5: Locating Nut, Washer And Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
11. Connect the park/neutral position switch connector.
  
  Fig 6: Locating Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Connect the control cable to the control shaft lever with the nut.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  Fig 7: Locating Nut And Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the control cable to the bracket with a new clip.
ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See ADJUSTMENT )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION (See INSPECTION )
INSPECT SHIFT LEVER POSITION (See ADJUSTMENT )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSTALL AIR CLEANER BRACKET (See INSTALLATION )
INSTALL INTAKE AIR RESONATOR SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 AIR CLEANER INLET (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
HINT:

Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).