Inspection Procedure

1. Check the DATA LIST to ensure proper function of the door unlock detection switch.

   BODY: 

   DATA LIST - BODY
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   P LOCK POS SW	Passenger side door lock position switch signal/ON or OFF	ON: Passenger side door lock is in UNLOCK position OFF: Passenger side door lock is in LOCK position	-

   OK: The display is as specified in the normal condition. 

NG: Go to step   2 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

1. Remove the front door lock assembly.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   MEASUREMENT CONNECTION SPECIFIED CONDITION REFERENCE TABLE
   
   

   Measurement Condition	Door Lock Condition	Specified Condition
   Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1	LOCK	7 - 8 (10 kΩ or higher)
   Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4	UNLOCK	7 - 8 (Below 1 Ω)

   Fig 1: Identifying Front Door Lock Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE FRONT DOOR LOCK ASSEMBLY 

OK: Go to next step. 

1. Disconnect the front door lock assembly connector.
2. Disconnect the instrument panel J/B connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION REFERENCE TABLE
   
   

   Tester Connection	Condition	Specified Condition
   D11-7 (LSSR) - B5-27 (LSWP)	Always	Below 1 Ω
   D11-8 (E) - Body ground	Always	Below 1 Ω

   Fig 2: Identifying Front Door Lock Assembly & Instrument Panel J/B Connectors Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE