Vane Pump: Installation

INSTALL VANE PUMP ASSEMBLY
1. Install the vane pump with the 2 bolts.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 1: Locating Vane Pump Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT PRESSURE FEED TUBE
1. Install a new gasket to the pressure feed tube.
2. Connect the pressure feed tube with the union bolt.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
  
  Fig 2: Locating Pressure Feed Tube Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
1. Connect the connector.
2. Attach the wire harness clamp.
  
  Fig 3: Locating Power Steering Oil Pressure Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT SUCTION HOSE
1. Connect the suction hose to the vane pump assembly with the clip.
  
  Fig 4: Locating Suction Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER HOSE ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER APRON SEAL FRONT RH (See INSTALLATION )
INSTALL FRONT WHEEL RH (See INSTALLATION )
ADD POWER STEERING FLUID
BLEED POWER STEERING FLUID (See ON-VEHICLE INSPECTION )
INSPECT FOR POWER STEERING FLUID LEAK
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL