Check Mode Procedure
NOTE:
Enter "Signal Check" from the "DTC Check" screen displayed on the Techstream to clear the output DTCs (both present and past).
HINT:
- DTCs can be stored more sensitively in check mode than in normal diagnosis mode.
- Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.
- CHECK MODE PROCEDURE (Using the Techstream)
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Select "Signal Check", and proceed with checking using the Techstream.