LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> LX 570 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Theft Deterrent / Keyless Entry >> Engine Hood Courtesy Switch >> Installation

Engine Hood Courtesy Switch: Installation

  1. INSTALL HOOD LOCK ASSEMBLY 
    1. Apply MP grease to the sliding areas of the lock.
      Fig 1: Applying Grease To Sliding Areas Of Lock
      G05631129Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the hood lock control cable.
      Fig 2: Identifying Hood Lock Control Cable
      G05631127Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the connector.
    4. Install the hood lock with the 2 bolts and nut.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    5. Install a new hood lock nut cap.
      Fig 3: Identifying Hood Lock Assembly Bolts And Nuts
      G05631126Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL HOOD LOCK CONTROL CABLE COVER 
    1. Attach the claw to install the cover.
    2. Install the 3 screws.
      3. Fig 4: Locating Hood Lock Control Cable Cover Screws
      G05631125Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)  (See INSTALLATION )
  4. INSTALL RADIATOR GRILLE ASSEMBLY  (See INSTALLATION )
  5. INSTALL UPPER RADIATOR SUPPORT SEAL  (See INSTALLATION )
  6. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  7. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  8. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) 
    1. Adjust millimeter wave radar sensor assembly (See ADJUSTMENT ).
scientia non olet · About LEMON Manuals