Radio Receiver: Removal

REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- w/ Navigation System:
  After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (See REMOVAL )
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (See REMOVAL )
REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See REMOVAL )
REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (See REMOVAL )
REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET (w/o Navigation System) (See REMOVAL )
REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET (w/ Navigation System) (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
1. Remove the 2 screws and 2 bolts.
  
  Fig 1: Locating Radio Receiver Assembly With Bracket Screws And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull the radio receiver to detach the 7 claws on the backside of the radio receiver.
3. Disconnect the connectors and remove the radio receiver.
  
  Fig 2: Identifying Radio Receiver Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 RADIO BRACKET
1. Remove the 3 bolts and bracket.
  
  Fig 3: Locating No. 1 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 RADIO BRACKET
1. Remove the 3 bolts and bracket.
  
  Fig 4: Locating No. 2 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002