On-Vehicle Inspection

CHECK SHIFT LOCK OPERATION
1. Move the shift lever to the P position.
2. Turn the power switch off
3. Check that the shift lever cannot be moved to any position other than P.
4. Turn the power switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.
CHECK SHIFT LOCK RELEASE BUTTON OPERATION
1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P. If the operation cannot be performed as specified, check the shift lever assembly.

CHECK SHIFT LOCK CONTROL ECU

Measure the voltage according to the values in the table below.

HINT:

Do not disconnect the shift lock control ECU connector.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION REFERENCE CHART

Tester Connection	Condition	Specified Condition
12 (IG) - 3 (E)	Power switch on (IG)	10 to 14 V
12 (IG) - 3 (E)	Power switch off	Below 1 V
6 (STP) - 3 (E)	Brake pedal depressed	10 to 14 V
6 (STP) - 3 (E)	Brake pedal released	Below 1 V
11 (P2) - 3 (E)	Shift lever in any position except P	10 to 14 V
11 (P2) - 3 (E)	Shift lever in P position	Below 1.5 V

Fig 1: Identifying Shift Lock Control ECU Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value in the table below.

HINT:

Do not disconnect the shift lock control ECU connector

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION REFERENCE CHART

Tester Condition	Condition	Specified Condition
3 (E) - Body ground	Always	Below 1 Ω

Fig 2: Identifying Shift Lock Control ECU Connector E Terminal

If the result is not as specified, replace the transmission floor shift assembly.