Toe Control Link: Installation

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS )

TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH
1. Insert the toe adjust cam from the front of the vehicle and connect the toe control link. Then temporarily install the No 2 suspension toe adjust plate with the nut.
  NOTE: Align the matchmarks of the No. 2 suspension toe adjust plate and suspension member.
  
  Fig 1: Aligning Matchmarks Of No. 2 Suspension Toe Adjust Plate And Suspension Member
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the toe control arm with a new nut to the axle carrier
  
  Fig 2: Locating Toe Control Arm With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH
1. Tighten the nut.
  Torque: 60 N.m (612 kgf.cm, 44 ft. lbf.)
  
  Fig 3: Tightening Toe Control Link Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the nut.
  Torque: 118 N.m (1203 kgf.cm, 87 ft. lbf.)
  
  Fig 4: Locating Toe Control Arm With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SKID CONTROL SENSOR WIRE (See INSTALLATION )
INSTALL LOAD SENSING VALVE SENSOR BRACKET (See INSTALLATION )
STABILIZE SUSPENSION (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 140 N.m (1428 kgf.cm, 103 ft. lbf.)
CHECK SUSPENSION CONTROL SYSTEM
1. Check the suspension control system (see ADJUSTMENT )
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
1. Inspect and adjust the rear wheel alignment (see ADJUSTMENT )
CHECK SPEED SENSOR SIGNAL
1. Check the speed sensor signal (see TEST MODE PROCEDURE )
ADJUST HEADLIGHT ASSEMBLY
1. For LED headlight
  Adjust the headlight (see ADJUSTMENT ).
2. For HID headlight:
  Adjust the headlight (see ADJUSTMENT )
ADJUST OBJECT RECOGNITION CAMERA
1. Adjust the object recognition camera (see ADJUSTMENT )