Inspection Procedure

CHECK HARNESS AND CONNECTOR (CLOCK - MULTI-DISPLAY)

Disconnect the L38 clock connector.
Disconnect the L60 display connector.
Measure the resistance according to the value(s) in the table below

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
L38-5 (TX-1) - L60-17 (TX3-)	Always	Below 1 Ω
L38-6 (TX+1) - L60-18 (TX3+)	Always	Below 1 Ω
L38-5 (TX-1) - Body ground	Always	10 kΩ or higher
L38-6 (TX+1) - Body ground	Always	10 kΩ or higher

Fig 1: Checking Harness And Connector (Clock - Multi-Display)

G04945881

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )