Outer Rear View Mirror: Removal

HINT.

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See REMOVAL )
2. REMOVE BATTERY SERVICE HOLE COVER LH  (See REMOVAL )
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
   NOTE:

   • After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the POWER switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REMOVAL )
5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See REMOVAL )
6. REMOVE DOOR FRAME GARNISH  (See REMOVAL )
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REMOVAL )
8. REMOVE FRONT MULTIPLEX NETWORK DOOR ECU  (See REMOVAL )
9. REMOVE FRONT NO. 2 DOOR SERVICE HOLE COVER  (See REMOVAL )
10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY 
    1. Disconnect the connector.
    2. Detach the 3 clamps.
    3. Remove the 3 nuts and mirror.
    Fig 1: Identifying Outer Rear View Mirror Assembly Nuts And Clamps

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002