Door Control Transmitter: Removal

REMOVE TRANSMITTER BATTERY
NOTE: Take extra care when handling these precision electronic components.
1. Push and hold the release knob in the direction indicated by the arrow in the illustration. Then take the mechanical key out of the case.
  
  Fig 1: Removing Mechanical Key From Transmitter Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert a precision screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 2: Detaching Transmitter Housing Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Insert a precision screwdriver into the gap and remove the battery (lithium battery: CR1632)
  NOTE:
  - Do not push the terminals with your finger.
  - Do not forcibly pry up the battery. The terminals may be damaged.
  - Do not touch the battery with wet hands. Water may cause rust.
  - Do not touch or move any components inside the transmitter. It may interfere with proper operation.
    
    Fig 3: Removing Battery (Lithium Battery: CR1632)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSMITTER BATTERY (for Card Type)
1. Lightly hold and pull the transmitter housing cover in the direction of the arrow as shown in the illustration.
  HINT:
  - If the battery cover is held too firmly, it becomes harder to pull out
  - If the cover is slippery and is difficult to pull out, use non-slip gloves to pull the cover out
  NOTE: Do not insert a screwdriver, etc. between the case and battery cover and forcefully bend the battery cover. This will deform the battery cover.
  
  Fig 4: Pulling Transmitter Housing Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the transmitter battery (lithium battery CR2412).