Inspection Procedure

HINT:

Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0096 AND/OR P0111) 
   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the Techstream ON.
   4. Enter the following menus: Powertrain / Engine / Trouble Codes.
   5. Read the DTCs.

      Result 

      RESULT CHART
      
      

      Display (DTC Output)	Proceed to
      P0096 and/or P0111 and other DTCs	A
      P0096 and/or P0111	B

      HINT:

      If any DTCs other than P0096 and/or P0111 are output, troubleshoot those DTCs first.

   B: REPLACE MASS AIR FLOW METER (BANK 1 AND/OR BANK 2)  (See REMOVAL )

   A: GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART )