Inspection Procedure

1. Check for the DTC (see DTC CHECK/CLEAR  ).

   Result: 

   RESULT REFERENCE TABLE
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

B: Go to  CAN COMMUNICATION SYSTEM 

A: Go to next step 

1. Operate the Techstream according to the display and select "Active Test".

   OK: Needle indication is normal. 

   Combination Meter: 

   ACTIVE TEST REFERENCE
   
   

   Tester Display	Test Part	Control Range
   Tacho Meter	Tachometer	0, 1000, 2000, 3000, 4000, 5000, 6000, 7000

   HINT:

   Confirm that the vehicle is stopped and engine is idling.

NG: REPLACE NO. 1 METER ECU  (See DISASSEMBLY  )

OK: Go to next step 

1. Operate the Techstream according to the display and select "Data List".

   OK: Engine speed displayed on Techstream is almost the same as actual engine speed. 

   Combination Meter: 

   MEASUREMENT ITEM/RANGE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Tacho Meter	Engine speed / Min.: 0, Max.: 12750	Idling: 700 to 800	Unit: rpm

NG: Go to step   4 

OK: REPLACE NO. 1 METER ECU  (See DISASSEMBLY  )

1. Operate the Techstream according to the display and select "Data List".

   OK: Engine speed displayed on the Techstream is almost the same as the actual engine speed. 

   Engine: 

   MEASUREMENT ITEM/RANGE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine Speed	Engine speed / Min.: 0, Max.: 16383.75	Idling: 700 to 800	Unit: rpm

NG: Go to  SFI SYSTEM 

OK: Go to next step 

1. Temporarily replace the combination meter with a new one (See DISASSEMBLY  ).

1. Check the operation of the tachometer returns to normal (see OPERATION CHECK  ).

   OK: Operation of tachometer returns to normal. 

NG: REPLACE ECM  (See REMOVAL )

OK: END (COMBINATION METER IS DEFECTIVE)