Inspection Procedure

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

B: GO TO CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to Next Step 

1. Check the Data List for proper functioning of the mirror master switch and mirror control switch.

   D-SEAT SW 

   D-SEAT SW REFERENCE CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Mirror selection SW (Right)	Mirror master switch signal for RH mirror / ON or OFF	ON: Switch is in R position OFF: Switch is OFF or in L position	-
   Mirror selection SW (Left)	Mirror master switch signal for LH mirror / ON or OFF	ON: Switch is in L position OFF: Switch is OFF or in R position	-
   Mirror Adjustment Right	Mirror control switch signal (RIGHT) /ON or OFF	ON: RIGHT switch is ON OFF: Any switch except RIGHT is ON or all switches are OFF	-
   Mirror Adjustment Left	Mirror control switch signal (LEFT) / ON or OFF	ON: LEFT switch is ON OFF: Any switch except LEFT is ON or all switches are OFF	-
   Mirror Adjustment Up	Mirror control switch signal (UP) / ON or OFF	ON: UP switch is ON OFF: Any switch except UP is ON or all switches are OFF	-
   Mirror Adjustment Down	Mirror control switch signal (DOWN)/ON or OFF	ON: DOWN switch is ON OFF: Any switch except DOWN is ON or all switches are OFF	-

   OK: On screen, each item changes between ON and OFF according to above chart. 

NG: REPLACE OUTER MIRROR SWITCH ASSEMBLY  (See REMOVAL  )

OK: USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )