Inspection Procedure
- CHECK DTC OUTPUT
- Clear the DTCs (see DTC CHECK/CLEAR ).
- Check for DTCs (see DTC CHECK/CLEAR
).
Result
RESULT REFERENCE TABLEResult Proceed to No DTC is output A DTC U1114 is output B DTC U1127 is output C B: GO TO CAN COMMUNICATION SYSTEM (See DTC U1114: LOST COMMUNICATION WITH MAIN SWITCH MODULE )
C: GO TO LIN COMMUNICATION SYSTEM (See DTC U1127: LOST COMMUNICATION WITH CENTER CONSOLE SWITCH ECU )
A: Go to Next Step
- READ VALUE USING TECHSTREAM (REAR SUNSHADE SWITCH)
- Use the Data List to check if the rear sunshade switch is functioning properly.
Center Console Switch
TESTER DISPLAY REFERENCE TABLETester Display Measurement Item/Range (Display) Normal Condition Diagnostic Note Rear Shade Switch Rear sunshade switch / ON or OFF ON: Rear sunshade switch is pressed
OFF: Rear sunshade switch is not pressed- OK: Rear sunshade raises or lowers.
NG: Go to step 3
OK: REPLACE NO. 1 CONSOLE SWITCH (See REMOVAL )
- Use the Data List to check if the rear sunshade switch is functioning properly.
- INSPECT NO. 2 CONSOLE SWITCH
- Disconnect the No. 2 console switch connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION TABLETester Connection Switch Condition Specified Condition 8 - 12 Rear sunshade switch Is pushed Below 200 Ω 8 - 12 Rear sunshade switch Is not pushed 10 kΩ or higher NG: REPLACE NO. 2 CONSOLE SWITCH (See REMOVAL )
OK: REPLACE NO. 1 CONSOLE SWITCH (See REMOVAL )