LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> LS 460L >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior >> Rear Sunshade Assembly >> Installation

Rear Sunshade Assembly: Installation

  1. INSTALL REAR SUNSHADE ASSEMBLY 
    1. Tighten the bolt labeled A.
    2. Install the sunshade with the 5 bolts.
      3. Fig 1: Identifying Sunshade With Bolts
      G04946672Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Attach the 5 claws and 3 clips to install the panel.
      2. Fig 2: Identifying No. 2 Package Tray Trim Panel Assembly Claws & Clips
      G04946667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL STEREO COMPONENT SPEAKER ASSEMBLY  (See INSTALLATION )
  4. INSTALL REAR NO. 4 AIR DUCT (w/ Rear Cooler)  (See INSTALLATION )
  5. INSTALL REAR NO. 5 AIR DUCT (w/ Rear Cooler)  (See INSTALLATION )
  6. INSTALL ROOF SIDE NO. 2 AIR DUCT LH (w/ Rear Cooler)  (See INSTALLATION )
  7. INSTALL ROOF SIDE NO. 2 AIR DUCT RH (w/ Rear Cooler)  (See INSTALLATION )
  8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. w/ Rear Cooler:

      Connect the solar sensor connector.

    2. Pass the rear seat belt floor anchors through the panel.
    3. Insert the rear part of the panel into the rear sunshade.
    4. Attach the 2 clips and install the package tray trim panel.
      Fig 3: Identifying Rear Seat Belt Floor Clips
      G04946666Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. except Ottoman Seat:

      Attach the 4 claws to install the 3 belt guides.

    6. for Ottoman Seat:

      Attach the 4 claws to install the 2 belt guides.

      Fig 4: Identifying Belt Guides Claws
      G04944524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL ROOF SIDE GARNISH INNER LH  (See INSTALLATION  )
  10. INSTALL ROOF SIDE GARNISH INNER RH  (See INSTALLATION  )
  11. INSTALL REAR SEAT SIDE GARNISH LH  (See INSTALLATION  )
  12. INSTALL REAR SEAT SIDE GARNISH RH  (See INSTALLATION  )
  13. INSTALL REAR DOOR SCUFF PLATE LH 
    1. for Standard Body:

      Install the rear door scuff plate (see INSTALLATION  ).

    2. for Long Body:

    Install the rear door scuff plate (see INSTALLATION  ).

  14. INSTALL REAR DOOR SCUFF PLATE RH 
    1. for Standard Body:

      Install the rear door scuff plate (see INSTALLATION  ).

    2. for Long Body:

    Install the rear door scuff plate (see INSTALLATION  ).

  15. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type) 
    1. Install the rear seat (see INSTALLATION ).
  16. INSTALL REAR SEAT ASSEMBLY (for Power Seat) 
    1. Install the rear seat (see INSTALLATION ).
  17. INSTALL REAR SEAT ASSEMBLY (for Ottoman) 
    1. Install the rear seat (see INSTALLATION ).
  18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  19. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
  20. PERFORM INITIALIZATION 
    1. Perform INITIALIZATION .
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  21. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals